Adhesive coating floor roll anti-slip modern art H60 x W200 cm

Floor stickers to enhance the decor of your home!

With the floor covering sticker and this Adhesive coating floor roll anti-slip modern art H60 x W200 cm, you can finally harmonize the decoration of your floor with that of your walls! Our non-slip floor stickers & imitation floor covering adhesive are very easy to apply. They can be easily cut with scissors to fit in every corner of your home.

- Installation advice: Peel the sticker off its backing and apply it to a smooth floor. Easy to install, no air bubbles.
- Waterproof and non-slip plastic surface
- Resistant to scratches and cleaning products
- Thickness: 0.2 mm

What is a floor sticker?

It is a large semi-flexible non-slip floor covering sticker approximately 0.2 mm thick, which you peel off its backing in order to apply it to a dry, clean and smooth floor. The floor covering is a vinyl printed and laminated on top. It is therefore resistant to claws, scratches, water, cleaning products and frequent foot traffic.

How to apply non-slip floor stickers?

Peel the floor sticker off its backing and apply it to a dry, clean, smooth and non-porous surface. Our special Easy Apply vinyl allows air to escape during installation. Installation is therefore quick and guaranteed to be bubble-free. The non-slip floor sticker can be repositioned at the start, allowing you to correct an installation error.

Can I cut a floor covering sticker?

Yes, our floor adhesive rolls can be easily cut with scissors or a cutter. If our non-slip floor covering is too large for your surface, simply cut off the excess edges with a ruler and a cutter, for example. It's quick and easy.

Can I cover a large surface with floor stickers?

You can apply several identical floor covering adhesives next to each other to cover a large surface. The result is often magnificent, even if they are the same stickers stuck next to each other. The ideal is to apply them edge to edge, but you can also superimpose one sticker on the edge of another. The low thickness of 0.2 mm is barely noticeable, even with bare feet.

Where to stick a non-slip floor adhesive roll?

The floor covering sticker will stick to any dry, clean, smooth and non-porous surface (tiles, wood, linnet, stone, raw or varnished parquet, glass wool, etc.). The sticker will stick even if it covers the joints of your tiles. Not recommended on: carpet, brick, gravel, uneven or dusty surfaces.

Does the floor covering adhesive leave marks?

The non-slip floor roll leaves no marks when removed for the first month. After three years, if you remove your floor sticker, it is possible that traces of glue will appear. Simply use a solvent or hot water to clean them. Your floor, tiles, linoleum, parquet or other will not be damaged.

Where to stick this decorative sticker?

Application advice

Peel the floor covering sticker off its backing and apply it to a dry, clean, smooth and non-porous surface (tiles, linoleum, stone, raw or varnished parquet, glass wool, etc.). The non-slip floor roll sticker will hold even if it covers the joints of your tiles. Not recommended on: carpet, brick, gravel, uneven surface.